Hotpoint LTF 11M113 7C, Инструкция по эксплуатации

Страница: 7 / 20

GB
7
Ensure the drain hose is securely
attached, to prevent it coming away
while the machine is in use and
causing a flood.
Fit hose to waste securely using
a “Jubilee” type clip.
Anti-flooding protection
*
To ensure floods do not occur, the dishwasher:
- is provided with a special system which blocks the water supply
in the event of anomalies or leaks from inside the appliance.
Some models are also equipped with the supplementary safety
device
New Acqua Stop
*
, which guarantees anti-flooding
protection even in the event of a supply hose rupture .
WARNING: HAZARDOUS VOLTAGE!
Under no circumstance should the water inlet hose be cut as it
contains live electrical parts.
The Company shall not be held responsible for any incidents
that occur if these regulations are not observed
Switching the appliance on for the first time
Advice regarding the first wash cycle
After the installation, remove the stoppers from the racks and
the retaining elastic elements from the upper rack, if any.
Immediately before the first washing, completely fill the salt
dispenser with water and add only then approximately 1
kg of salt (see chapter entitled Rinse aid and refined salt).
The water may overflow: this is normal and is not a cause
for concern. Select the water hardness value (see chapter
entitled Rinse aid and refined salt). - After the salt has been
poured into the machine, the LOW SALT indicator light*
switches off.
If the salt dispenser is not filled, the water softener and the
heating element may get damaged as a result.
The machine has a buzzer/set of tones
(depending on the
dishwasher model
) to inform the user that a command has
been implemented: power on, cycle end etc.
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
light
(depending on the dishwasher model) .
The display provides useful information concerning the type
of wash cycle, drying/wash-cycle phase, remaining time,
temperature etc etc.
Transportation
Unload all crockery from the dishwasher and secure moving
parts.
All water remaining inside the appliance should be drained
as follows:
make sure that the water tap is open and select the ECO cycle.
The cycle will begin. After 5 minutes, end the cycle by pressing
the ON/OFF button until you hear a beep and the indicator lights
switch off. Wait for approximately 5 minutes before uninstalling
the appliance. Shut off the tap and disconnect the inlet and
drain hose.
The appliance should only be moved in an upright position, in
order to prevent any water remaining inside the appliance from
damaging dishwasher components.
Leaving the machine unused for extended periods/
Freezing protection
If the appliance is situated in a location which is at risk of
freezing, or if you intend to be away for extended periods of time
(e.g. holiday home) , empty the appliance completely.
- Carry out the process used to drain all water remaining inside
the appliance
(see Transportation).
- Disconnect the appliance from the electricity supply and shut
off the water tap.
- Leave the appliance door ajar.
- When you return, run a cycle while the dishwasher is empty .