HOW TO OPERATE YOUR DISHWASHER
STEP 1. Load your dishwasher with dishes, silverware,
pots, pans, bowls, etc., according to the Loading section.
STEP 2. Add detergent to the detergent dispenser.
Make sure the Cycle Indicator Dial is OFF position
before adding detergent. (See Detergent Guide).
Use rinse aid agent to help prevent spotting. Occasionally
check to insure that rinse agent container is at least half
full.
How to Use a Rinse Agent section).
STEP 3. Select drying option.
DRYING HEAT ON. Turns the
drying heater on for fast drying.
DRYING HEAT OFF. Turns
HEAT
ON OFF
m
the drying heater
to save energy.
The dishes will dry naturally over a
period such as overnight.
If you need your dishes sooner, open the dishwasher
door after the cycle is complete to reduce the natural
drying time.
Use of this option reduces the electrical energy
used by this model approximately
for the
NORMAL WASH cycle.
STEP 4. WATER HEAT energy
ON: The wash cycle will be
extended for 9 minutes
the dishwasher heats the water
for good washing and drying.
The entering water must beat
least
saver option
WATER HEAT
OFF
m
OFF: The entering water must be
at least
See How to Test the
Water Temperature section.
STEP 5. Select the wash cycle
start the dishwasher.
(See Cycle Selection Hints).
If your dishwasher drains into a food waste disposer,
operate the disposer until it is empty before starting
the dishwasher.
To obtain the benefits a complete cycle,
be careful that you do not turn the dial any
farther than necessary to start the dishwasher.
●
For POTS & PANS, NORMAL WASH
and WATER SAVER cycles:
a. Push selected cycle button.
b. Latch the door.
c. Slowly turn Cycle Indicator
to START position to
start the
You will hear
the motor start. There is a
time delay between the start-
up and the water fill so you
.
.
.
will not hear any wash action right away.
c. Latch door to start the cycle.
●
For RINSE & HOLD cycle:
a. Be sure door is unlatched.
b. Select DRYING HEAT
OFF drying option.
c. Slowly turn the Cycle
Indicator Dial to the
.
6:
oFF
●
●
RINSE &HOLD
O
.
RINSE & HOLD position.
Latch the door to start the cycle.
●
When NOT using DELAY START (for all cycles):
a. Be sure door is unlatched.
b. Push selected cycle button.
c. Slowly turn Cycle Indicator Dial to START.
d. Latch the
to start the dishwasher.
●
When using DELAY START (for all cycles except
RINSE & HOLD):
Note: START
be delayed
automatically
up to 6 hours.
a. Be sure door is unlatched.
b. Push selected cycle button.
c. Slowly turn Cycle Indicator
Dial to desired delay time.
.
.
d. Latch door to start timer.
The
DELAY light will come
and
stay on until dishwasher starts. Dishwasher
will start automatically at end selected delay time.
4