Installation tips
WARNING – THIS APPLIANCE MUST BE EARTHED.
Electrical connection
Electric cookers come without a power supply
cable. The cooker is designed to operate on an
electricity supply which conforms to the electrical
data shown on the Rating Plate. The cooker can be
connected to the mains only after removing the
back panel of the cooker itself with a screwdriver.
N.B.:
N.B.:
N.B.:
N.B.:
N.B.: the following installation procedure must be
carried out by a qualified electrician. The electrical
installation must comply with the IEE Regulations,
Building & local By-Lays.
For the installation of the feeding cable carry out
the following operations:
1 Open the terminal
board by inserting a
screwdriver into the
side tabs of the cover.
Use the screwdriver
as a lever by pushing
it down to open the
cover (see diagram).
2
Loosen the cable clamp screw and remove
it, using a screwdriver as a lever (see figure).
3. Remove the wire
contact screws L-N-
,
then fasten the wires
under the screw heads,
respecting the colour
code: Black/Blue (N),
Red/Brown (L) and Bare
Wire/Yellow-Green (
).
Once the connections have been made, tighten
all the terminal screws fully.
Fasten the supply cable in place with the clamp
and close the cover of the terminal board.
The height of the cooker can be adjusted by means
of adjustable feet in the plinth (900mm - 930mm).
Adjust the feet by tilting the cooker from the side.
Then install the product into position.
NOTE: This appliance must not be fitted on a
platform.
The appliance must not be installed behind
a decorative door in order to avoid overheating
Technical Characteristics
Main Oven
Dimensions (HxWxD):
Volume: 62 Litres
Max. Oven Power Absorption: 1700 W
Voltage and Frequency:
(see data plate)
Declared energy consumption for
Natural convection Class
heating mode: Fan oven
37 x 40,5 x 41 cm
EN
EN
6
! This procedure must be performed by a qualified
technician who has been authorised by the
manufacturer.
! This procedure must be performed by a qualified
technician who has been authorised by the
manufacturer.
! This procedure must be performed by a qualified
technician who has been authorised by the
manufacturer.
