24
GB
Care and Cleaning
Hotplate Burner Caps and Pan Supports
Cloth wrung out in warm soapy water. Stubborn
stains can be removed with a cream paste, liquid
cleaner or by rubbing with fine steel wool soap
pads.
NB. Check that the cleaning agent is approved by
the Vitreous Enamel Association.
Hotplate Burner Bodies
Use a nylon brush to remove any cleaning materials,
water or dirt from the hotplate burner bodies.
Door and Control Panel (Glass)
Regularly wipe with a clean, damp cloth and polish
with a clean, dry cloth.
Door and Control Panel Trims (Stainless Steel)
Regularly wipe with a clean, damp cloth and polish
with a clean, dry cloth.
Solarplus Grill
To clean the solarplus grill use a clean, damp cloth
and wipe over. If stubborn stains remain, gently
clean with a well soaped nylon scouring pad and
wipe over with a damp cloth.
NOTE: DO NOT use metal cleaning utensils, wire
wool or proprietary oven cleaners on the grill
element mesh.
WARNING: TO AVOID ELECTRIC SHOCK,
BEFORE REPLACING THE OVEN LIGHT,
SWITCH THE COOKER OFF AT THE COOKER
CONTROL UNIT (and allow to cool if the oven
has been used).
Replacement of the Oven Light
Unscrew the glass cover, using a suitable cloth to
protect the fingers and remove carefully. Unscrew
the existing light bulb, and remove. Screw the new
bulb into position and replace the glass cover, with
metal washer, until positioned securely.
CLEANING THE DOORS
Take particular care not to damage the inner
surface of the door inner glass that is coated with
a heat reflective layer. Do not use scouring pads,
or abrasive powder, which will scratch the glass.
Ensure that the glass panel is not subjected to
any sharp mechanical blows.
Stubborn stains can be removed by using a fine
steel wool soap pad. For slight soiling the inner
glass panel may be cleaned, while still warm,
without removing it from the door. After cleaning,
rinse and dry with a soft cloth.
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop
down doors, except take care to support the weight
of the inner glass when removing and refitting.
DROP DOWN DOORS
Remove the door inner glass as follows.
1. Open the door fully and remove the extrusion
end caps (This should be done by hand but if it
proves too difficult, simply lift the inner glass to
ease the end caps out of position).
NOTE: If you need to use a tool - be
NOTE: If you need to use a tool - be
NOTE: If you need to use a tool - be
NOTE: If you need to use a tool - be
NOTE: If you need to use a tool - be
careful not to damage the extrusion or
careful not to damage the extrusion or
careful not to damage the extrusion or
careful not to damage the extrusion or
careful not to damage the extrusion or
end cap.
end cap.
end cap.
end cap.
end cap.
2. Carefully slide the inner glass towards you and
withdraw it from its locating slots. Ensure that
the door is not allowed to slam shut, due to the
reduction in door weight. Clean the glass as
described above.
3. The inside of the outer door glass can now be
cleaned while still fitted to the cooker.
NEVER OPERATE THE COOKER WITHOUT THE
INNER DOOR GLASS IN POSITION.
Refit the door inner glass as follows.
1. Open the door fully.
2. Locate the inner door glass into its slots, so that
the printing is readable from the face nearest the
oven in the closed position and the widest black
band is towards the bottom of the door. The
inner door glass has a special reflective coating
on one side, in order to minimise surface
temperatures and energy consumption during
use, it is important it is fitted correctly.
3. Carefully slide the glass into its slots as far as it
will go and replace the end caps.