Hotpoint DLB2750B, Инструкция по использованию и уходу

Страница: 11 / 16

The Problem Solver
PROBLEM
POSSIBLE CAUSE AND REMEDY
SHRINKAGE,
Relaxation shrinkage can in knit fabrics that have been improperly stretched
KNITS and elongated by the manufacturer. When this occurs, garment may be pressed back into
shape after each wash and dry cycle.
●
Progressive or delayed shrinkage is caused when starch or sizing some fabrics) is
removed by laundering. Maybe noticed that have been
many times without previous shrinkage. Treat as for Shrinkage above.
●
that have been
shaped. When wasting, drying or ironing temperatures exceed the temperatures used
shape set, shrinkage may occur. This cannot be corrected, but it can be prevented by
washing in cold or warm water; drying on (Low).
●
Leaving clothes in dryer tumbling stops. Remove clothes and hang
PERMANENT PRESS them immediately.
AND “NO-IRON”
ITEMS
●
Too many items in dryer. Dry only one washer load at Do not combine loads.
Too few items in dryer. If drying only one article, add similar articles, even
if dry, to insure proper tumbling.
●
hems,
as work clothes,
with Permanent Press items, such as shirts or blouses. not wash or dry
Permanent Press with regular laundry.
Too many clothes in washer. Items must have room to move freely. Permanent Press
loads should always be smaller than regular loads.. more than medium loads.
●
Use of incorrect wash and dry cycles. Use Permanent Press Wash Cycle which provides
a cool-down rinse to Also, use Permanent Press (Medium)
selection.
. Incorrect water level. Use Water Fill for medium load; Medium Fill for
small load.
Washing in too hot water. Wash in cool or warm water with plenty of detergent.
11