Cover
Drawers at the bottom of the fresh
food compartment will stop before
coming
the way out of the
refrigerator, to help prevent contents
from spilling onto floor. These
drawers can be removed easily by
grasping the sides and lifting up
slightly while pulling drawers past
the “stop” location.
To remove
and
cover
when the
compartment
door cannot be opened fully:
and remove
3. Reach in, push the front of the
glass cover up and, at the same
time, pull it forward until it clears
the frame at the back.
4.
and remove the glass cover.
5. Remove the 3 drawer
slides.
Remove the drawer frame as
follows:
●
Lift the front of the frame to free
it from the supports at each side.
●
Lift the rear of the frame to free
its hooks from the tracks on the
back wall of the refrigerator.
. Tilt the frame and
it out.
To
replace:
1. Fit the hooks on the drawer
frame into the
bottom slots on the tracks at the
rear of the refrigerator and lower
the front of the frame until it locks
into position and rests on the front
supports at each side.
2. Put the drawer slides back on
the frame. The sloped ends must
beat the front.
3. Slide the center and right drawer
slides toward the middle and slide
the l/3-width drawer all the way
into them.
4.
the l/3-width drawer the
way to the right.
5. Mount the 2/3-width drawer
onto the center and left slides.
Replace the glass cover, pushing
its rear edge firmly into the rear
frame channel and gently lowering
the front into place.
11
