13
Maintenance and Care
Impor
tant
Inf
ormation
Description
Star
t
and
Programmes
L
aundry
W
arnings
and
Suggestions
Maint
enanc
e
and
Care
Installation
T
roubleshooting
Servic
e
GB
Empty the water container after each
cycle
Pull the container out of the dryer and empty it into a
sink or other suitable drain.
Replace the water container securely.
Always check and empty the container before you
start a new drying programme.
Cleaning the condenser unit
Periodically (every month) remove the condenser unit
and clean any build up of fluff from between the plates
by rinsing it under the tap with cold water. This should
be done with cold water from the rear of the
condenser.
Removing the condenser:
1. Unplug the dryer and open the door.
2. Pull open the condenser cover (
see diagram
).
Release the three catches by turning 90˚ counter-
clockwise then pull on the grip and remove from
the dryer.
3. Clean the surface of the seals and replace with the
arrows pointing upwards, making sure that the
catches have been secured.
Cleaning the dryer
●
External parts in metal or plastic and rubber parts
can be cleaned with a damp cloth.
●
Periodically (every 6 months) vacuum the front air
intake grille and vents at the rear of the dryer, to
remove any build up of fluff, lint or dust. Also to
remove accumulation of fluff from the front of the
condenser and filter areas, clean occasionally with
a vacuum cleaner.
!
Do not use solvents or abrasives.
!
Your dryer uses special bearing components which
do not need lubrication.
!
Have your dryer checked regularly by authorised
technicians to ensure electrical and mechanical safety
(
see Service
).
Switching off the electricity
!
Unplug your dryer when not using it, when cleaning it
and during all maintenance operations.
Clean the filter after each cycle
The filter is an important part of your dryer:
it accumulates lint and fluff that is formed while drying.
When finished drying, clean the filter by rinsing it
under running water or with your vacuum cleaner.
Should the filter become clogged up, the airflow inside
the dryer will be seriously compromised: drying times
lengthen and you will consume more energy. It may
also damage your dryer.
The filter is found in front of the dryer trim (
see diagram
).
Removing the filter:
1. Pull the plastic grip of the filter upwards (
see diagram
).
2. Clean the filter and replace it correctly.
Ensure the filter is fully located flush into the
tumble dryer trim.
!
Do not use the dryer without replacing the filter.
Check the drum after each cycle
Turn the drum manually in order to remove small
items (handkerchiefs) that could have been left
behind.
Cleaning the drum
!
Do not use abrasives, steel wool or stainless steel
cleaning agents to clean the drum.
A coloured film may start to appear on the stainless
steel drum, this may be caused by a combination of
water and, or cleaning agents such as fabric conditioner
from the wash. This coloured film will not affect the
dryers performance.
Water container
Handle
Condenser cover
Catches
Air intake
Filter
Tap
Rear
Front
Condenser unit
Condenser unit
