The Controls
Heat Selection
Switch
Start
switch
Empty water
light
Clean Filter
light
Drying
light
Timer
Control
The drying time for both heat settings is controlled by the timer. All you
have to do is turn the Timer Control clockwise until the required time
appears in line with the indicator.
NEVER WIND THE TIMER CONTROL ANTI-CLOCKWISE.
The “Guide to Drying Times” section will tell you how much time you’ll
need for various loads.
To select high heat (Cottons), the Heat Selection switch must be IN.
To select Low heat (Acrylics and Synthetics) the Heat Selection switch
must be OUT.
See section “Guide to Drying Times”.
Press and release the START button to commence a drying program
(The drying time must have been selected first).
This light glows during the drying part of the programme except for the
short periods during the drum reverse action.
When the door is opened this light will glow to remind you to clean the
filter.
This light will glow when the water container is full.
You should not wait for this light to glow before emptying the water
container, but empty it after each load (see section “Emptying the
Water Container”).
NOTE: When the light glows you must stop the dryer and empty the
water container.
If the water light glows during a drying cycle the timer will advance to
the Cool Tumble Phase without drying the load.
The light will take approximately 10 seconds to go out after replacing
the empty container.
Setting the timer
Selecting the
required Heat
Setting
Starting the Dryer
Drying light
Clean Filter light
Empty Water
Light
NOTE: If the door is opened during a programme the
Dryer will automatically stop.
To continue the programme after closing the door, the
START button must be pressed.
9
