Hotpoint AQUALTIS AQC9 4F7, Инструкция

Страница: 8 / 20

8
GB
To open door
Dryer Description
Control Panel
The On/Off button/light , if the dryer is running and this
button is pressed and held for more than 3 seconds the dryer
is turned off. The light signals that your dryer is in use or ready
to select a programme.
The
Programmes knob sets the programme: rotate until the
indicator is pointing to the programme you want to select (see
Start and Programmes).
The
Option
buttons/ lights select available options for your
selected programme. The lights indicate that the option has
been selected (see Start and Programmes).
The Display Panel has three sections: Sensor Dry = Drying
level, Timed dry = Drying time and Time to End / Delay start
each with a corresponding selection button
(see The Display).
START/PAUSE button with indicator light : when the
green indicator light flashes slowly, press the button to
start the programme. When the cycle has started, the
indicator light is illuminated in a fixed manner. To pause
the programme, press the button again; the indicator light
will turn orange and begin to flash again. To restart the
programme from the point at which it was interrupted, press
the button again (see Start and Programmes).
The Programme Progress Lights indicate each state of the
programme by turning on as appropriate.
(see Start and
Programmes).
Note: this light also flashes amber during post care phase.
The Empty Water indicator
“ h2o ”
signals that the water
container should be emptied. The light will take a few seconds
to go out after replacing the empty water container; the dryer
must be running for this to happen (see The Controls).
Note: if the water bottle is full the display shows “ h2o ” and the
indicator flashes, the heat is turned off and your clothes will
not dry.
The
Empty Water Clean Filter Light gives a reminder
before every programme, that its essential to clean the filter and
empty the water container every time the dryer is used
(see
Maintenance and Care).
The Clean Heat Pump Filter Light gives a reminder, that its
essential to clean this filter at regular intervals (see Maintenance
and Care).
The
Child Lock
button/light Press and hold this button after
selecting your programme and any options. This prevents the
programme settings from being changed.
When the light is lit the other buttons and programme knob are
disabled. Hold the button to cancel and the light will go out.
ECO Light
- this light is illuminated as you select options that
use less energy (see the controls).
The Features
Pull on handle
Water
container
Rating
Plate
Filter
Air Intake
Grille
Model
& Serial
Numbers
Heat Pump Filter
Unit
(cover open)
Heat Pump Filter Unit cover
handle
(Pull here to open)
Clean Heat
Pump
Filter
Ajustable feet
(to level dryer)
Option Buttons and Lights
On/Off Button & Light
Display Panel
Child Lock
Button & Light
Start/Pause
Button & Light
Programme
Progress Light
Programme Knob
Empty
Water /
Clean Filter
Light
ECO
Light
Sensor Dry
Timed Dry
Delay
Timer