26
GB
Switching the appliance off
Disconnect your appliance from the electricity supply
before carrying out any work on it.
Cleaning the appliance
The stainless-steel or enamel-coated external parts
and the rubber seals may be cleaned using a
sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for the
removal of stubborn stains. After cleaning, rinse and
dry thoroughly. Do not use abrasive powders or
corrosive substances.
The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with a
soft cloth. Do not use abrasive products.
All accessories - with the exception of the sliding
racks - can be washed like everyday crockery, and
are even dishwasher safe.
We recommend that detergents are not sprayed
directly onto the control panel, but that a sponge is
used instead.
Never use steam cleaners or pressure cleaners on
the appliance.
Cleaning the oven door
Clean the glass part of the oven door using a sponge
and a non-abrasive cleaning product, then dry
thoroughly with a soft cloth. Do not use rough abrasive
material or sharp metal scrapers as these could
scratch the surface and cause the glass to crack. For
more thorough cleaning purposes, the oven door may
be removed:
1. Open the oven door fully
(
see diagram
).
2. Lift up and turn the small levers located on the two
hinges (
see diagram
).
With glass panel fitted to
the inside of the door
Glass door
Seal
Lamp
Oven
compartment
3. Grip the door on the two
external sides and close it
approximately half way. Pull the
door towards you, lifting it out
of its slot (
see diagram
).
3. (With glass panel fitted to
the inside of the door) Grip the
door on the two external sides
and close it approximately half
way. Unlock the door by
pressing on the clamps
FFFFF
, then
pull the door towards you lifting
it out of its seat (
see diagram
).
To replace the door, reverse this sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the
seals are damaged, please contact your nearest After-
sales Service Centre (
see Assistance
). We recommend
that the oven is not used until the seals have been
replaced.
Replacing the light bulb
To replace the
oven light bulb:
1. Remove the glass cover using a screwdriver.
2. Remove the light bulb and replace it with a similar
one: Wattage 15 W, cap E 14.
Replace the glass cover, making sure the seal is
positioned correctly (
see diagram
).
Care and maintenance
F
F
