22
GB
C
ar
e
a
nd
m
a
in
t
en
a
n
c
e
S
w
i
tc
h
in
g
t
h
e
a
pp
l
i
a
n
c
e
o
ff
Disconnect your appliance from the electricity
supply before carrying out any work on it.
Cleaning the appliance
The stainless-steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for
the removal of stubborn stains. After cleaning,
rinse and dry thoroughly. Do not use abrasive
powders or corrosive substances.
The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
All accessories - with the exception of the sliding
racks - can be washed like everyday crockery,
and are even dishwasher safe.
Never use steam cleaners or pressure cleaners on
the appliance.
Cleaning the oven door
Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crack.
For more thorough cleaning purposes, the oven door
may be removed:
1. Open the oven door fully
(
see diagram
).
2. Lift up and turn the small
levers located on the two
hinges (
see diagram
).
3. Grip the door on the two
external sides and close it
approximately half way.
Unlock the door by pressing
on the clamps
F
, then pull the
door towards you, lifting it out
of its slot (
see diagram
). To
replace the door, reverse this
sequence.
Ins
p
ectin
g
t
h
e
seals
Check the door seals around the oven regularly. If
the seals are damaged, please contact your nearest
After-sales Service Centre (
see Assistance
).
W
e
recommend that the oven is not used until the seals
have been replaced.
Replacing the light
b
ul
b
To replace the oven light bulb:
1. Remove the glass cover of the lamp-holder.
2. Remove the light bulb and replace it with a similar
one:
W
attage 25
W
, cap E 14.
3. Replace the glass cover (
see diagram
).
F
F
