Hotpoint Ariston CP87SG1 /HA, Руководство по эксплуатации

Страница: 25 / 64

G B
2 5
S w it ch in g t he a pp li a n ce o ff
Disconnect your appliance from the electricity
supply before carrying out any work on it.
C l e a nin g t he a pp li a n ce
Never use steam cleaners or pressure cleaners on
the appliance.
• The stainless steel or enamel-coated e x ternal
parts and the rubber seals may be cleaned using
a sponge which has been soaked in lukewarm
water and neutral soap. Use specialised products
for the removal of stubborn stains. After cleaning,
rinse well and dry thoroughly. Do not use abrasive
powders or corrosive substances.
• The hob grids, burner caps, flame spreader rings
and burners may be removed to make cleaning
easier; wash them in hot water and non-abrasive
detergent, making sure all burnt-on residue is
removed before drying them thoroughly.
• Clean the terminal part of the flame failure safety
devices* frequently.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
• Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product,
then dry thoroughly with a soft cloth. Do not use
rough abrasive material or sharp metal scrapers
as these could scratch the surface and cause the
glass to crack.
• The accessories can be washed like everyday
crockery, and are even dishwasher safe.
Do not close the cover when the burners are alight
or when they are still hot.
Inspecting the oven seals
Check the door seals around the oven regularly. If
the seals are damaged, please contact your nearest
Authorised After-sales Service Centre. We
recommend that the oven is not used until the seals
have been replaced.
G a s t a p m a int e n a n ce
Over time, the tap may become jammed or difficult
to turn. If this occurs, the tap must be replaced.
This procedure must be performed by a
qualified technician who has been authorised by
the manufacturer.
Rep l a c in g t he o ve n li gh t b u l b
1. After
disconnecting the
oven from the
electricity mains,
remove the glass
lid covering the
lamp socket ( see
figure ).
2. Unscrew the
light bulb and
replace it with a
similar one: voltage 230 V, wattage 25 W, cap E 14.
3. Replace the lid and reconnect the oven to the
electricity supply.
A ss i s t a n ce
Never use the services of an unauthorised
technician.
Please have the f ollowing in f ormation to hand :
• The type of problem encountered.
• The appliance model (Mod.).
• The serial number (S/N).
The latter two pieces of information can be found on
the data plate located on the appliance.
Care and maintenance