17 of 26
Indesit
Company
Service Manual UK
English
DISMANTLING INSTRUCTIONS
Safety Notes
1. Ensure that the appliance is disconnected from the electrical supply before dismantling.
2. Beware of sharp edges on metal panels, plastic mouldings, and pressed parts.
3. Some fixings (especially those into plastic) must be tightened to the correct specification
using a suitable torque wrench.
4. Insulation resistance tests must be carried out with the pressure switch set to ensure that
the water heater is 'in-circuit' during the test.
A
Table Top
1.
Remove the 2 screws at the top rear of cabinet.
2.
Slide the table top backwards to disengage the location fixings at the rear and lift off.
B
Lower Rear Access Panel
1.
Remove 2 screws from the lower rear access panel.
2.
Pull the top edge of the panel out and disengage it from its location fixings along the bottom.
C
Dispenser Drawer
1.
Open the dispenser drawer fully.
2.
Lift the right hand side of the dispenser. Pull forward to remove.
D
Console Panel
1.
Remove the table top (A) and dispenser drawer (C).
2.
Remove the dispenser hinge pivot pin, slide the programme chart from the dispenser housing.
3.
Remove 2 top screws securing console to cabinet and two screws securing console to dispenser.
4.
Unplug wiring from console PCB.
5.
Unclip 2 plastic lugs securing console panel to front panel and lift clear.
E
Console PCB & Button Assemblies
1.
Remove the console panel (D).
2.
Remove wiring plug.
3.
Remove 5 securing screws and lift away from the console. All the buttons/programme knobs will lift
clear with the PCB.
F
Pressure Switch
1.
Remove the table top (A).
2.
Disconnect the wiring connection block and pressure hose.
3.
Carefully unclip bracket from cabinet side and then unclip switch from bracket.
