Hotpoint Ariston Aqualtis AQGL 109, Инструкция пользователя

Страница: 11 / 48

GB
11
Troubleshooting
Possible causes / Solutions:
• The plug has not been inserted into the electrical socket, or it has not
been inserted far enough to make contact.
• There is no power in the house.
• The porthole door has not been shut properly.
• The START/PAUSE button has not been pressed.
• The water tap has not been turned on.
• The water inlet hose is not connected to the tap.
• The hose is kinked.
• The water tap has not been turned on.
• There is no water in the house.
• The water pressure is insufficient.
• The START/PAUSE button has not been pressed.
• The end of the outlet hose has not been fitted at a height between 65
and 100 cm from the floor ( see “Installation”).
• The free end of the hose is underwater ( see “Installation”).
• If If the dwelling is on one of the upper floors of a building, there may be
problems relating to water drainage, causing the washing machine to
load and drain water continuously. Special anti-draining valves are
available in shops and help to avoid this inconvenience.
• The water drainage systemis not fitted with a breather pipe.
• The programme does not include a draining phase: some programmes
require manual draining ( see “Programmes and options”).
• The “Easy Iron” option is enabled: to complete the programme, press
the START/PAUSE button (see “Programmes and options”).
• The outlet hose is bent ( see “Installation”).
• The drainage duct is clogged.
• The drum was not unlocked properly when the appliance was installed
(see “Installation”).
• The washing machine is not level ( see “Installation”).
• The washing machine is trapped between cabinets and a wall (see “Installation”).
• The load is not balanced properly ( see “Description of the machine”).
• The water inlet hose is not screwed on to the tap correctly ( see “Installation”).
• The detergent dispenser drawer is blocked (for instructions on how to
clean it, see “Care and maintenance”).
• The outlet hose has not been secured properly ( see “Installation”).
• Switch off the machine and unplug the appliance; wait for approximately
1 minute then switch it on again.
If the problem persists, contact Assistance.
• The detergent is not designed for machine washing (the packaging
should state that the product is “for washing by machine”, “for washing
by hand or machine” or similar).
• Too much detergent was used.
• Follow the manual unlocking procedure (see “Precautions and tips”).
If the problem persists after the above checks have been carried out, shut
off the water tap, switch off the machine and contact Assistance.
From time to time your machine may not operate as it should. Before calling for Assistance ( see “Assistance”) ,
make sure that the problem cannot be resolved easily using the following list.
Malfunction:
The washing machine
will not switch on.
The wash cycle
does not begin.
The washing machines fails to
fill with water.
The machine continuously fills
and drains water.
The machine does not drain
or spin.
The washing machine vibrates
too much during the spin cycle.
The washing machine leaks.
The icons corresponding to the
“Phase in progress” flash
rapidly at the same time as the
ON/OFF indicator light.
There is too much foam.
The washing machine door
remains locked.