14
5. Select a display mode and monitor your
progress with the display.
When the manual
mode is selected,
the console offers
seven display
modes. The dis-
play mode that you
select will determine which workout information is
shown. Press the Display button repeatedly to se-
lect the desired display mode.
As you walk or run on the treadmill, the upper dis-
play can show the following workout information:
• The elapsed time.
• The distance that you have walked or run.
• The speed of the walking belt.
• The incline level of the treadmill.
• The approximate number of calories you have
burned.
• The approximate number of calories burned per
hour.
• Your exercise intensity in METs. One MET is the
amount of energy you use while resting.
• Your walking or running pace, in minutes per
mile or minutes per kilometer.
• Your power output in watts.
• An animation of a road.
Regardless of which display mode you select, the
speed or incline setting will appear in the display
for a few seconds each time you change the set-
ting.
As you switch between workouts and the manual
mode, the console will keep track of the total dis-
tance that you have walked or run and the approxi-
mate number of calories you have burned. You can
keep your totals even when you switch to a new
workout. To reset the console, press the Clear but-
ton.
6. Measure your heart rate if desired.
Before using
the handgrip
pulse sensor,
remove the
sheets of clear
plastic from
the metal con-
tacts. In addi-
tion, make
sure that your
hands are clean.
To measure your heart rate,
stand on the foot
rails and hold the contacts for approximately
ten seconds—avoid moving your hands.
When
your pulse is detected, your heart rate will be
shown.
For the most accurate heart rate read-
ing, continue to hold the contacts for about 15
seconds.
7. Turn on the fan if desired.
The fan has high and low speed settings. Press the
Fan button repeatedly to select a fan speed or to
turn off the fan. Note: If the fan is on when the
walking belt stops, the fan will automatically turn off
after a few minutes.
8. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, re-
move the key from the console, and put it in a se-
cure place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the “off” position and
unplug the power cord.
IMPORTANT: If you do
not do this, the treadmillʼs electrical compo-
nents may wear prematurely.
Contacts
