IV. TRANSMITTER
Transmitters are equipped with a special automatic ON
battery-saving feature. Just turn your vehicle ON. Then
push either transmitter stick and you will be able to run and
control your vehicle.
TRANSMITTER
1. To install the transmitter battery, open the battery cover as
shown.
2. Install 2 AA batteries with polarity (+/-) as shown inside the
battery compartment.
3. Replace the battery cover.
V. POWER CLIP
Please check the package for the specific power system for this
vehicle:
Vehicles use the Tyco® R/C 4.8V Jet Turbo® rechargeable NiCd
Battery Pack & Charger.
For detailed information regarding NiCd battery charging and
safety, please follow the specific instructions that came with your
battery pack and charger.
VEHICLE BATTERY INSTALLATION
These instructions apply to the 4.8V Jet Turbo® rechargeable NiCd
Battery Pack.
1. Rotate the battery latch to the open position.
2. Insert the rechargeable NiCd battery pack) into the battery
compartment and slide it away from the latch.
3. Make sure the rechargeable NiCd battery pack) snaps securely
in place. Rotate the latch to the locked position.
4. To remove: turn the latch, slide it toward the latch and lift it out.
VI. 4.8V JET TURBO® NiCd
1. Rotate the battery latch to the open position.
2. Insert the battery pack into the battery compartment and slide it away
from the latch.
3. Make sure the battery pack snaps securely in place and rotate
the latch to the locked position.
4. To remove the battery pack: turn the latch, slide the battery pack
toward the latch and lift it out.
BATTERY CHARGING/CARE – 4.8V JET TURBO® BATTERY
X
CAUTION:
Use only the charger supplied with this toy. Do not
use any other charging source.
1. Plug the wall pack charger into a standard wall outlet.
2. Click the battery pack into the charger. Make certain the battery
pack is secure in the charger.
3. To disconnect, push the red button on the side of charger and
simultaneously slide the battery pack out.
4. After charging, the battery will feel warm. This condition is
normal for fully charged batteries.
5. New battery packs must be charged for 10 hours the first
two times charged. Subsequent charges will require 6 hours.
Charging the battery pack for more than 6 hours will not give you
a longer running time. 6 hours is all that is required for a fully
charged battery pack.
6. Unlike alkaline batteries, where the power loss is gradual, a NiCd
battery will run for its normal running time and then lose most of
its power at once. That's when you'll know it is time to recharge
the battery pack.
2 xAA/LR6
7. After use, the battery pack will be hot! Wait at
least 20 minutes until the battery pack cools before
recharging. Recharging a warm or hot battery pack
will greatly reduce the number of times your battery
pack can be recharged. Charge only TYCO® R/C
Jet Turbo® 4.8V NiCd 700 or 800mAh rechargeable
battery packs. Other types of batteries may burst
and causing injury to persons and damage.
8. The charger must be disconnected
from the electric supply.
w
r
y
e
q
t
4.8V d.c.
NiCd
1X4 "AA"
w
r
y
e
q
t
w
r
y
e
q
t
