1
2A9584-010
Hoshizaki IM-500SAB Stacking Kit Instructions
HS-5530
For Use with Hoshizaki Model IM-500SAB
Check to ensure that all parts are included:
Index
No. Description
Part
Number
Qty
Index
No. Description
Part Number Qty
1
Ice Chute
1A5929-01
1
6
Water Guide
4A6891-01
1
2
Wire Harness
3B0590-01
1
7
Wire Saddle
4A2338-01
2
3
Top Panel Hook
3B0586-01
1
8
Wiring Label
2A9601-01
1
4
Thumbscrew
415949G01 2
9
Hex Bolt w/Washer (8×16) 7B0230816
2
5
Gasket
(125×1080 mm (5"×42 1/2"))
4A0808L02 1
10
Hex Nut (M8)
7N12-0800
2
WARNING
• Only qualified service technicians should install this kit to reduce the risk of death, electric shock, serious injury,
or fire.
• Icemaker is heavy. Use care when lifting or positioning. Work in pairs when needed to prevent injury or damage.
• No installation or service should be undertaken until the technician has thoroughly read these instructions. Failure
to follow these instructions will adversely affect safety, performance, component life, and warranty coverage.
•
Before Servicing
: Move the control switch to the "OFF" position and turn off the power supply. Place the
disconnect in the "OFF" position. Lockout/Tagout to prevent the power supply from being turned back on
inadvertently. Control switch in "OFF" position does not de-energize all loads.
•
CHOKING HAZARD:
Ensure all components, fasteners, and thumbscrews are securely in place after the
icemaker is serviced. Make sure that none have fallen into the dispenser unit/ice storage bin.
• Make sure all food zones in the icemaker and dispenser unit/ice storage bin are clean after service.
• Protect the floor when moving the icemaker to prevent damage to the floor.
• Wear proper PPE (personal protection equipment) when executing these procedures.
• To reduce the risk of electric shock, do not touch the control switch with damp hands.
• The manufacturer cannot be held responsible for injury or damage resulting from improper, incorrect, and
unreasonable use or installation.
NOTICE
• Do not use the frame to lift the icemaker. Lift the icemaker at the base or use a duct jack to lift the upper icemaker
on top of the lower icemaker
• Up to three icemakers total (including the bottom icemaker) can be stacked.
Double Stacked: IM-500SAB × 2, Stacking Kit HS-5530 × 1
Triple Stacked: IM-500SAB × 3, Stacking Kit HS-5530 × 2
• The bin control switch on the lowest icemaker controls all icemakers. The bin control switch and switch mount
must be removed from the upper icemakers. Misconnection or no connection may cause damage to the
icemakers, resulting in icemaker failure or damage.
• Allow 6" (15 cm) clearance at rear, left side, and top (upper icemaker), and 12" (30 cm) clearance at right side for
proper air circulation and ease of maintenance and/or service should they be required.
New Lower Icemaker Installation Instructions
1) Follow the Instruction Manual's installation instructions through "II.D. Setup."
When complete, continue to step 2.
Note: If installing an upper icemaker on an existing lower icemaker,
skip to step 2.
Lower Icemaker
Ice Storage Bin
