ENGLISH
4
4. ELECTRICAL CONNECTIONS
IMPORTANT
This refrigerator/freezer is provided with no
power switch or earth leakage circuit breaker,
but with overcurrent protection (fuse) only.
Install a switch rated at least 10A on the main
power supply.
* This refrigerator/freezer must be plugged into
the separated power receptacle which is readily
accessible and has enough capacity. The
maximum allowable voltage variation should not
exceed ± 10 percent of the nameplate rating. See
the nameplate.
5. OPERATION
IMPORTANT
1. B e c a r e f u l n o t t o w e t t h e m a c h i n e
compartment. This might cause failure or
electric shock hazard.
2. To prevent electric shock, do not touch the
attachment plug with wet hands.
3. This refrigerator/freezer is designed only
for temporary storage of foods. Use for any
other purposes (e.g. storage of chemicals
or medical supplies such as vaccine and
serum) could cause deterioration of stored
items.
4. Do not throw anything onto the shelves or
load more than 30 kg on each of them. They
may fall off and cause injury.
5. Do not store bottles or cans near the air
outlet. They may freeze up and break,
causing a risk of injury.
6. Do not use combustible spray or place
volatile and flammable substances near the
unit. They could catch fire from a spark of a
switch or the like.
7. Do not put anything into the machine
compartment or the air inlet/outlet. The fan
rotating rapidly inside may cause injury or
heat.
8. Energise the refrigerator/freezer for 1 hour
and check for proper temperature before
putting foods in the cabinet.
9. Do not block the air inlet/outlet with foods.
Fig. 6
Shelf Clip
Shelf Post
Push
Hook
3) Tilt the unit backward to mount the front legs or
casters (work in pair).
Fig. 5
4) Mount the rear legs or casters in the same way.
When mounting the casters, lock the two front
casters before mounting the rear ones, or the unit
will slide when tilted.
5) Before operating the unit, remove all shipping
carton, packing, tape(s) and protective plastic film
on the exterior and top panel. Be careful not to
damage the exterior panels.
6) Position the unit in a selected site.
7) Clean the interior with a soft cloth soaked in cold
or warm water containing the proper amount of
neutral cleaner and wrung dry.
8) Level the refrigerator/freezer in both the left-to-
right and the front-to-rear directions (levelness:
within 1°).
3. SHELF AND SHELF CLIP
* The shelf is adjustable in 1” increments. Adjust the
shelf clips according to the height of stored items.
* To attach the shelf clip, insert the upper tab into
an adjust hole in the shelf post to hook the shelf
clip, and push the lower tab into another adjust
hole until it locks in place. To detach the shelf clip,
reverse the above procedure.
CAUTION
Attach the shelf clips properly to make the
shelf level.
