16
8) Remove the louver and air filter. Move the control switch to the "OFF" position, pause
momentarily, then move the control switch to the "DRAIN" position. Allow the water
system to drain completely (you will see the water draining into the drain pan). Move the
control switch to the "OFF" position.
Note: a) A momentary pause in the "OFF" position is necessary to de-energize the
control board when moving the control switch between "DRAIN" and "ICE."
Otherwise there is a delay of several minutes before the new selection takes
effect.
b) If control switch is left in the "DRAIN" position for 10 minutes or more, a 2-beep
alarm sounds every 5 seconds. If this occurs, move the control switch out of
the "DRAIN" position to clear the alarm.
9) Dispense all of the ice from the ice storage bin. Also confirm that the water dispenser is
operating correctly.
10) Move the power switch to the "OFF" position, then unplug the appliance from the
electrical outlet.
11) Remove the bin top. Clean the ice storage bin liner and actuator using a neutral cleaner.
Rinse thoroughly after cleaning.
NOTICE!
Be sure to keep the micro switch mounted
on the bin top dry.
Power Switch
Control Switch
Louver
Air Filter
Front Panel
Top Panel
Bin Top
Actuator
Fig. 5
Agitator
Drain Pan
Storage Bin
Power Cord
Micro switch
12) Move the control switch to the "ICE" position.
13) Replace all removed parts and panels in their correct positions. On the push-button
model, reconnect the connector (5VDC).
WARNING! CHOKING HAZARD: Ensure all
components, fasteners, and thumbscrews are securely in place. Make sure that
none have fallen into the ice storage bin.
14) Plug the appliance into the electrical outlet. Move the power switch to the "ON" position
to start the automatic icemaking process.
Spout
Grille
Connectors
