37
the fan motor assembly into the unit. Connect the fan motor wires, then replace the
removed parts in the reverse order of which they were removed.
6) Replace the louver and panels in their correct positions.
7) Plug the unit back in. Move the power switch to the "ON" position.
E. Removal and Replacement of Water Reservoir
1) Move the power switch to the "OFF" position, then unplug the unit from the electrical
outlet.
2) Close the water supply line shut-off valve.
3) Remove the upper rear panel. See Fig. 9.
4) Remove the clamp securing the drain plug, then lower the drain hose into a container.
Remove the drain plug to drain the water from the reservoir and evaporator assembly.
5) After all of the water has drained, replace the drain hose, drain plug, and drain clamp in
their original positions.
6) Loosen the inlet fitting on the top of the reservoir.
7) Disconnect the hoses from the water reservoir.
8) Remove the reservoir bracket and reservoir.
9) Remove the reservoir from the reservoir bracket.
10) Install the new reservoir onto the reservoir bracket.
11) Replace the removed parts in the reverse order of which they were removed. Before
replacing the rear panel, open the water supply line shut-off valve and check for water
leaks.
12) Plug the unit back in. Move the power switch to the "ON" position.
F. Removal and Replacement of Bin Control Thermostat Assembly
1) Move the power switch to the "OFF" position, then unplug the unit from the electrical
outlet.
2) While maintaining a hold on the door, remove the hinge stop pin from hinge (B). Pull out
the bottom of the door slightly, then gently remove the door from hinge (A). See Fig. 7.
3) Remove the top panel.
4) Remove the thermostat holder from the storage bin, then remove the bin control
thermostat bulb from the holder.
5) Disconnect the thermostat wires. Disconnect the thermostat heater wires. Remove the
bin control thermostat assembly from the unit.
6) Install the new bin control thermostat assembly in the reverse order of the removal
procedure.
7) Replace the removed parts in the reverse order of which they were removed.
8) Plug the unit back in. Move the power switch to the "ON" position.