3
FITTING OF VALVE BODY TO PIPEWORK
Fit the valve body using the 22mm
compression fittings provided. Tighten
the compression nuts sufficiently to make
a watertight seal, only gripping
the valve by its body. Take care not to
over tighten.
FIT ACTUATOR TO VALVE BODY
Position the actuator on the valve body
lining up the valve spindle with the ‘D’
shape slot. A yellow guide strip has
been inserted behind the override lever
to assist installation; please remove the
guide once the actuator installation is
complete and before the system is used.
The actuator guide holes should line up
with the spigots on the valve body.
Fix with the screws provided and tighten
lightly. Set the override lever to manual.
Fill, test and thoroughly flush the system.
Installation - continued
