horsch Maestro RC Central Fill 1230, Руководство пользователя

Страница: 60 / 108

60 Maestro RC Owner’s Manual – Ver. 2.1 10/2019
www.horsch.com
Parking the Machine
Thoroughly clean the seed tank and seed on
demand system. Corrosion to components is at
higher risk when left uncleaned.
Park the planter in a shed or under a roof so that
no moisture can accumulate in the tank,
metering unit or seed tubes.
With negative hitch load, the machine may tilt
back and cause severe injury to persons. Lower
the machine correctly before unhitching! The
proper use of the stabilizing jacks on the front
and rear of the machine will aide in a safe
unhitching procedure!
ATTENTION! CAT 3/4N Quick Hitch compatible.
Parking
1. Always park the machine horizontally on
firm ground. Shut down the tractor.
2. Secure the machine at the support
wheels with wheel chocks against rolling
away.
3. Unfold the machine.
4. Lower the seed toolbar (wings).
5. Relieve any hydraulic pressure in the
system.
6. Disconnect hydraulic and electrical
connections. Attach connections to the
hydraulic hose holder and electrical plug
holder located on the front toolbar.
7. Use the front and rear mounted jack
stands to support the machine weight off
the tractor rear three-point hitch.
8. Remove the hitch pins to unhitch the
machine.
NOTE: The machine may be parked and
unhitched in a folded position, providing
extra precaution is taken, but is not
recommended!
Maestro RC Hitch Points (CAT 3/4N)
Cleaning
Always wear the required protective equipment
when cleaning. Harmful dusts or chemicals may
have deposited in the area of pneumatics and
hydraulics of the machine, along with the
metering units.
1. Empty the seed tank.
2. Clean the metering units, SOD system,
and hoses.
3. Open the covers on the end of the toolbar
(if equipped) for the vacuum system.
Use compressed air to thoroughly clean
any seed and dressing residues.
Storage (end of season)
1. Park the machine in an undisturbed area,
out of the way of other equipment.
2. Follow procedures above for proper
cleaning.
3. Follow procedures above for proper
parking of the machine.
4. Follow procedures above for proper
unhitching of the machine.
Top Link
Upper Hitch
Point (x1)
Lower
Hitch
Point (x2)