horsch Leeb 5.280 VL, Руководство по эксплуатации

Страница: 243 / 308

Illuviation of preparations
Illuviation valve
DANGER
Wear appropriate protective outfit for the
illuviation of the preparations.
Observe the regulations and notes as well as the
safety data sheet of the crop protection agent
manufacturer!
NOTE
Turn on the agitator for filling and the illuviation
of preparations. To maintain a homogeneous
mix, the agitator should remain activated until
the spraying operation is finished. The intensity
of the agitator can be set via the external control
terminal (only with water systems Basic Pro and
CCS Pro)
Observe the regulations and notes of the crop
protection agent manufacturer!
NOTE
Depending on the position of the ball valve of
the suction side, water exits from the fresh wa -
ter tank or spraying mixture from the spraying
mixture container on the illuviation valve.
Crop protection agent and carbonyl diamide are
poured into the illuviation valve, dissolved and
drawn in.
Swing the illuviation valve down by pulling it by
the handle.
Flush the respective preparation through the
illuviation valve into the water of the spraying
mixture container. A difference is in this case
made between the illuviation of fluid and pow -
dery preparations or carbonyl diamide.
5
1
2
3
4
1 Activate/deactivate the canister flushing
2 Activate/deactivate the washing gun
3 Activate/deactivate the shock nozzles
¾
The shock nozzles support the illuviation of difficult
to dissolve crop protection agents.
¾
Two rinsing nozzles and the shock nozzles in the
lower area of the Illuviation valve are activated.
4 Activate/deactivate the washing nozzles
5
Switch-over ball valve for sucking-off and external
filling devices
NOTE
Care must be taken when cleaning the illuviation
valve that no undesirable point-type entries of
preparations are generated!
MF 239