horsch Leeb 4 AX, Руководство по эксплуатации

Страница: 59 / 161

Washing gun
The illuviation valve can be cleaned after filling
with the washing gun. Apart from this, deposited
residues can be flushed out of the canisters.
9
17
Washing gun
¾
To fix the handle actuation press the button (17)
during operation.
¾
Press the handle to release.
¾
After switching off (9) relieve the residual
pressure.
NOTE
Depending on the position of the ball valve of
the suction side, water exits from the fresh wa-
ter tank or spraying mixture from the spraying
mixture container on the washing gun. Activate
the washing gun to this end (9) and clean the
illuviation valve.
Agitator
The spraying mixture container is equipped with
a hydraulic agitator. Special injector nozzles in
the agitator tube reinforce the stirring intensity.
The switched on agitator mixes the spraying
mixture inside the spraying mixture container
and thus generates a homogeneous mixture.
Set the ball valve on the pressure side to agitator.
Switch on the PTO-shaft. Stirring is done with
full power.
The intensity of the agitator can be manually
adjusted via the bypass valve during circulation/
spraying and road travel. To do so, the ball valve
of the pressure side must be set to circulation/
spraying and the PTO-shaft activated.
To minimise the residual quantity in the spray-
ing mixture container, the agitator can also be
completely disabled.
Agitator nozzles
55