MAN0979-01-EN_XHSQ_XHSQ-5_Datasheet
Specifications / Installation
©Horner APG, LLC. No part of this publication may be reproduced without the prior agreement and written permission of Horner APG, LLC. Information in this document is subject to change without notice.
8/28/2013
HEXHSQ / HEXHSQ-5
24 / 5 V dual Channel High Speed PWM or Stepper Output Modules
1.
SPECIFICATIONS
Parameter
HEXHSQ
HEXHSQ-5
Model Limitations
Number of Channels
2
2
Model #
Series Name
PWM
Stepper
Output range
6-30 VDC
5 VDC
HE-XE/HE-XT
HEXE/HEXT240
XLe / XLt
2 channels 8MHz
(50% duty) max
1 stepper
5KHz max
External supply range
6-30 VDC
Internally powered
HE-XL/HE-XV
HEXT35X/HEXT501
XL6 / XL10
2 Channels
500KHz Max
1 stepper
5KHz max
Nominal Output impedance
50Ω
50Ω
Short Circuit protection
Foldback,
200mA loaded
90mA shorted
100mA shorted
HE-XC/HE-XW
HEXT251/HEXT391
XL4 / XL7
2 Channels
500KHz Max
2 steppers
500KHz max
See the relevant product manual for PWM and Stepper register mapping and
configuration. Requires f/w 12.94 or higher and Cscape 9.3 SP5 or higher.
Stepper on model 0
2’s
requires f/w 12.96 or higher.
Isolated
1K VDC
1K VDC
Output Supply voltage
n/a
50mA max @ 5V
Output frequency
0-400 KHz
0-8MHz
Mark Space ratio
0-100%
0-100%
Operating temperature
-
10 to 60⁰C
-
10 to 60⁰C
Compliance
CE, UL, see compliance table at:
http://heapg.com/support/compliance.htm
http://www.horner-apg.com/en/support/certification.aspx
2.
WIRING
–
I/O
Wiring specification: It is recommended that shielded I/O wiring is used. Use Belden 8441, 18 AWG or larger or equivalent.
Terminal Connector
HEXHSQ
Name
1
Q1
2
Q2
3
C
4
V+
Terminal Connector
HEXHSQ-5
Name
1
Q1
2
Q2
3
C
4
VO
1
4
1
4
The HEXHSQ requires external power
between 6 and 24 volts dc.
The HEXHSQ-5 is a 5 volt only card that uses internal power and must
not have power applied. VO is an isolated 5 volt output available for
powering input circuitry of devices receiving the PWM signals.
