LMAN0009-03-EN
ETG-LRP INSTALL SHEET
6/20/2014
No part of this publication may be reproduced without the prior agreement and written permission of Horner Lighting Group, LLC. Information in this document is subject to change without notice.
Page
4
of
5
4) Clip a reflector lock on each end of the tube by pressing down evenly in the center (refer to
arrows in figure 2), locking them into place.
5) Remove protective coating from the reflector prior to powering on the light.
6) Clean reflectors with a non-abrasive mild soap or neutral PH cleaner to rid them any installation
smudges.
4. WIRING
WARNING
Risk of electrical shock
. Disconnect power before servicing or installing product.
Risque de choc électrique.
Coupez l'alimentation avant l'entretien ou l'installation du produit.
Make all electrical connections in accordance with the National Electrical Code and local code
requirements.Verify that supply voltage is correct by comparing it to the nameplate.
The wire lead from the luminaire power supply should be connected to the service wiring.
The standard power supply will have the following connections:
Wire Color
Function
Green/Yellow
Ground
Brown
A/C Live
Blue
A/C Neutral
If the 0-10V dimming option is added, the following two-wire terminal block will be added to the luminaire:
Wire Color
Function
Blue
DIM +
White
DIM -
Figure 2 - Reflector installed
