CLEANING
It is very important that the powder is cleaned out of the Auto Charge Pro after each
use. The Auto Charge Pro should not be used as a powder storage device. To easily
clean out the unit perform the following steps.
• Slide Auto Charge to the edge of a table, with the Powder Empty Spout hanging
over the edge of the table.
• Hold the proper powder container below the Powder Empty Spout, and slowly
rotate the spout so that the powder will dump into the container.
• Once the powder has been emptied out of the hopper, close the powder empty
spout.
• Place the powder pan on the Auto Charge as if a charge is going to be thrown.
• Touch
DISPENSE
on the screen to empty out the trickle tube. If the charge weight
is smaller than the amount of powder left in the tube, this will need to be repeated
more than once.
• After all powder is out of the trickle tube, repeat steps 1 and 2 to remove the rest of
the powder.
• At this time, remove the powder hopper and use the included brush to clean out the
rest of the powder from the hopper.
• Close the powder empty spout when finished.
WARRANTY
The Hornady Auto Charge
®
Pro is a highly sensitive instrument, which must be
repaired and serviced by a factory qualified technician to maintain the warranty.
Hornady Manufacturing warrants to you that for one year from the date of purchase,
your Auto Charge
®
Pro will be free from defects in material and workmanship.
This warranty does not cover damage caused by normal wear, accidents, abuse,
or failure to provide proper care and maintenance. Please contact Hornady
Manufacturing at 1-800-338-3220 for service or warranty information.
The warranty is void if the seal on bottom of unit has been tampered with.
P.O. Box 1848, Grand Island, Nebraska 68802-1848
308-382-1390 • 800-338-3220 • Fax: 308-382-5761
www.hornady.com • Hornady.com/contact_us
680091
19HMC0152 | 03/2020
