Horizon Signal SQ3TS, Руководство пользователя

Страница: 14 / 34

14
PARAMETER
Quartz sub.: Disabled
2 Phases 2 Contr.
Program name
Syst. 2 x 2
Programming
Save program
“Syst. 2x2”?
Yes
3. Set the green times for Phase 1. The first number on the screen is the base
green. This is the minimum amount of green time a given phase will allow
without detection. The second number is the extension time. The extension will
only be applied if the system is using some form of vehicle detection. If you are
not using detection, the extension will be ignored. Base green plus extension
equlas your maximum green time.
When set to “Yes,” Rest in Red means that the given phase will only go green in the
event of a vehicle detection. When set to “No,” the signal will cycle as normally.
4. Set the green times for Phase 2. These values can differ from those set for Phase
1.
5. Quartz substitution allows the signal system to continue to operate following a
communications loss. It utilizes quartz clock timing for synchronization between
signals. Signals are not in communication when this mode is enabled.
6. Your program can be given a custon name to help identify it. Use the Plus and
Minus buttons to change each character, and press E to advance the cursor.
7. Finally, the Programmer gives you the option to save the program you created.
While it is not a requirement, it may be helpful in the future to have a stored copy
of the program for future use/edits.
PROGRAM 1 / C1
Green: 10 s
Extension: 45 s
Rest in Red: No
PROGRAM 1 / C2
Green: 25 s
Extension: 30 s
Rest in Red: No