Horizon Reverse Osmosis Seafari Quest Compact 200, Руководство пользователя

Страница: 29 / 116

2. Connect main power using cable recommendations. The main power cable is inserted through one of the large
strain reliefs on the side of the controller enclosure.
3. Connect the Booster Pump motor power through the other large strain relief on the side of the controller enclosure
to terminals.
4. Connect the Freshwater Flush (FWF) Boost Pump using the supplied cable. Loosen the FWF strain relief on
the controller enclosure and insert the cable.
5. Connect UV Sterilizer using supplied purple cable. Loosen the other small strain relief on the side of the controller
enclosure and insert the purple cable. Connect to the PC Board.
Hose Lines
REJECT WATER 5/8” HOSE LINE
Use the 5/8” braided hose to connect the 1/2” hose barb on the ETD outlet labeled “S” to the 1/2” hose barb on
the Reject Water Assembly. The Reject Water Assembly should be connected to the Thru-Hull Discharge Fitting.
PRODUCT LINES - 1/4” BLACK TUBE
Use the 1/4” black tube to connect the tube connection on the bottom of the Product Manifold to the tube connection
on the Membrane Vessel Assembly. Use the 1/4” black tube to connect the tube connection on top of the Product
Manifold to the tube connection on the boat’s product tank.
REJECT LINES - 1/2” BLACK TUBE
Use the 1/2” black tube to connect the tube connection on the bottom of the Product Manifold to the tube connection
on the Reject Water Assembly.
FEED WATER 5/8” HOSE LINE
Use the 5/8” braided hose to Connect the 1/2” hose barb on the 3/4” Inlet Elbow Assembly to the Sea Strainer
inlet. Always use two 3/4” hose clamps when assembling the 5/8” braided hose. Connect the outlet of the Sea
Strainer to the Booster Pump then to the check valve assembly inlet. Connect the check valve assembly outlet to
the high pressure inlet. Connect the high pressure outlet to the prefilter inlet Tee.
Required Hose and Tube Connections
** = Supplied by Installer or Owner
*** = Optional Accessory
1. Connect Feed and Freshwater Flush Lines with the supplied 20 feet (6 meters) of 1/2” (12.7 mm) I.D. Inlet
Suction Hose. Secure the hose with two hose clamps offset 180 degrees at each fitting. Ignore any optional
accessory that is not to be installed:
to Inlet of: from Outlet of: Step
Sea Strainer Feed Water Connector 1.
***Inlet 3-Way Clean/Rinse Valve
(left or right port)
Sea Strainer 2.
***Inlet 3-way Clean/Rinse Valve
(left or right port)
**Rinse/Clean bucket or container 3.
Booster Pump ***Inlet 3-way Clean/Rinse Valve
(center port)
4.
Freshwater Flush Check Valve Booster Pump 5.
***Plankton Filter Freshwater Flush Check Valve 6.
Prefilter 25 micron ***Plankton Filter 7.
27
Installation