4
EN
Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifi er)
code of a single specifi c transmitter. You need to ‘bind’ your chosen Spektrum
™
DSM2/DSMX technology
equipped aircraft transmitter to the receiver for proper operation.
Any full range Spektrum DSM2/DSMX transmitter can bind to the DSM2/DSMX receiver. Please visit www.
bindnfl y.com for a complete list of compatible transmitters.
Transmitter and Receiver Binding
Binding Procedure
1. Refer to your transmitter’s unique instructions for binding to a receiver (location of transmitter’s
Bind control).
2. Make sure the fl ight battery is disconnected from the aircraft.
3. Power off your transmitter.
4. Place the aircraft on a level surface away from wind.
5. Connect the fl ight battery in the aircraft. The receiver LED will begin to fl ash rapidly (typically after
5 seconds).
6. Make sure the transmitter controls are neutral and the throttle and throttle trim are in low position.
7. Put your transmitter into bind mode. Refer to your transmitter’s manual for binding button or
switch instructions.
8. After 5 to 10 seconds, the receiver status LED will turn solid, indicating that the receiver is bound to
the transmitter. If the LED does not turn solid, refer to the Troubleshooting Guide at the back of
the manual.
For subsequent fl ights, power ON the transmitter for 5 seconds before connecting the fl ight battery.
IMPORTANT:
After you set up your model, always
rebind the transmitter and receiver to set the desired
failsafe positions.
If your transmitter allows it, enable the throttle
cut feature. Always engage throttle cut before
approaching the aircraft.
Dual Rates
Low rate is recommended for the initial fl ights.
NOTICE:
To ensure AS3X
®
technology functions
properly, do not lower rate values below 50%.
NOTICE:
If oscillation occurs at high speed, refer
to the Troubleshooting Guide for more information.
Expo
After your initial fl ights, you may adjust the expo
value to better suit your fl ying style.
Computerized Transmitter Setup
(DX6, DX6e, DX7, DX7S, DX8, DX8e,
DX9, DX10t, DX18, DX20, iX12 and iX20)
Start all transmitter programming with a blank ACRO
model (do a model reset), then name the model.
Reversing
All Normal
Dual Rates
HIGH 100%
LOW 70%
Expo
No Expo
Servo Travel
100%
Timer
5 minutes
Set Throttle cut to
-130%
Transmitter Setup
