5
EN
Model Assembly
Horizontal Tail Installation
1. Wipe the mounting areas on the horizontal tail halves and fuselage with a
paper towel to pick up any dust or loose paint before applying glue.
2. Use CA glue to attach the horizontal tail halves to the fuselage. Apply a thin
layer on the horizontal tail mounting surfaces of the fuselage.
3. Attach the horizontal tail halves to the fuselage as shown in the diagram.
4. Press the horizontal tail halves into position and wipe off any excess glue that
seeps out with a paper towel.
5. Leave the model level upside down hold the stabilizers in position while the
glue cures.
Sub Fin Installation
1. Wipe the mounting areas on the sub fi ns and the fan cover with a paper
towel to pick up any dust or loose paint before applying glue.
2. Use CA glue to attach the sub fi ns to the fan cover. Apply a thin layer in the
fi n mounting cavity on the fan cover.
NOTICE:
Do not apply glue to the front half of the sub fi n where they meet
the fuselage. The sub fi ns should be glued to the fan cover only. If the
front half sub fi ns are also glued to the fuselage, the fan cover cannot be
removed for access to the ducted fan.
3. Insert the sub fi ns into the fan cover as shown in the diagram to the
right. Verify the sub fi ns are angles outward as shown below.
4. Press the sub fi ns into position and wipe off any excess glue
that seeps out with a paper towel.
5. Leave the model level upside and secure the sub
fi ns in position while the glue cures.
NO GLUE
Apply glue here
Rear view, upside down. Verify
the sub fi ns are angled outward.
Apply glue here
