EN
5
Transmitter Setup
The Alpha-6 Stability System works out of the box with your current transmitter
setup. Only the Gain Direction and Transmitter stick calibration is necessary.
See
Setup Mode
below.
Setup Mode
To enter Setup Mode
1.
Hold down the program button while powering on the Alpha-6 Stability
System.
2.
Continue holding the button, the Main LED will flash and the channel
LED’s will cycle on and off. Once the main LED turns a solid Red, release
the program button.
3.
the Alpha-6 is now in Gain Reverse mode.
Gain Reverse Mode
4.
Ensure the main LED is glowing solid Red. Repeat the above steps until
the LED Glows Red.
5.
The selected channel’s LED will glow solid Green. (Blinking Green LED
indicates this channel is reversed)
6.
Push the program button once to move up through the channels to the
channel that needs reversed gain.
7.
Push and hold the program button for 3 seconds and the Green LED will
start blinking. This channels gain is now reversed.
8.
Push the program button once to move up through the remaining
channels.
9.
Perform the AS3X Control Direction test until all controls move the correct
direction.
10. Once all controls are correct, cycle up through the channels and the
Alpha-6 will exit Reversing Mode and enter Calibration Mode. The main
LED will blink Blue.
• Flight Mode
• Gains
• Attitude
• Roll/Pitch/Yaw rates
• Voltage(in)
• G Force
Telemetry
The 2 Xbus ports on the side of the Alpha-6 can be used for telemetry data
from the stability system connected to the Spektrum TM1000 telemetry module
(SPM9548). the stability system can also be daisy chained to other telemetry
sensors via the second XBus port.
The Alpha-6 Stability System reports:
