EN
4
LOSI
®
22S PRO NO PREP DRAG ROLLER: 1/10 SCALE 2WD • INSTRUCTION MANUAL
1. Install the ESC. Connect the motor wires to the ESC. Refer to the ESC manual for more
information.
2. Run the throttle lead to the receiver box.
3. To power auxiliary options such as lights, run the leads into the receiver box.
3. Remove the four (4) screws that hold the right-side mud guard.
4. Remove the servo brackets from the chassis, and mount the servo with the output shaft
toward the right side of the chassis.
5. Remove the servo horn from the steering link.
6. Center the steering servo by plugging the servo into the receiver, or using a servo checker.
Install the servo horn so the ball is 90°.
NOTE:
Before installing the servo horn, verify the transmission servo trim is centered.
7. Slide the servo into position on the chassis, and loosely secure the assembly to the chassis
using the two (2) rear screws.
8. Route the servo wire down the right mud guard using the supplied hooks to guide
the wire to the receiver box. Then secure the mud guard using the four (4)screws from
underneath.
9. Replace all the screws that were removed during the disassembly.
10. Secure the steering link to the servo horn ball to complete the servo installation.
INSTALL THE RECEIVER
1. Remove the two receiver box lid screws, and install the receiver with double-sided or hook
and loop tape.
2. Insert the servo and ESC connectors into the appropriate ports on the receiver.
3. Connect the steering drag link to the servo saver (not yet connected to the servo).
4. Verify the steering servo is centered and traveling in the correct direction.
5. With the steering linkage centered, connect the servo saver to the servo, and install the
included servo screw.
6. Check the steering direction and travel, and fine tune the center point using the transmitter
settings. See the transmitter manual for additional information.
TLR
LOK
INSTALL THE ESC