BINDING
Binding is the process of programming the receiver to recognize the GUID (Globally Unique
Identifier) code of a single specific transmitter.
The transmitter and ESC/receiver are
bound at the factory.
If you need to rebind, follow the instructions below:
1.
Insert the bind plug into the bind port of the receiver.
2.
Connect a fully charged battery to the ESC/motor.
3.
Power on the ESC/motor.
4.
Power ON the transmitter. The receiver’s red LED will turn solid when the bind is successful.
5.
Power OFF the ESC/motor to save the settings.
6.
Power OFF the transmitter.
You must rebind when binding the receiver to a different transmitter.
NOTICE:
Do not attempt to bind the transmitter and receiver if there are other compatible
transmitters in bind mode within 400 feet. Doing so may result in unexpected binding.
5
EN
LOSI MINI NO PREP CHEVELLE DRAG CAR • INSTRUCTION MANUAL
1. Steering Wheel
Controls direction (left/right) of the model
2. Throttle Trigger
Controls speed and direction (forward/brake/reverse) of the model
3. Power Button
Turns the power ON/OFF
4. Steering (ST-R) Servo Reversing
Reverses the steering channel
5. Throttle Limit
Limits throttle output to 50/75/100%
Select 50% or 75% for less experienced drivers or when you are driving the vehicle in a small area
6. Indicator Lights
-
Solid red light—
Indicates radio connectivity and adequate battery power
-
Flashing red light—
Indicates the battery voltage is critically low. Replace the batteries.
7. Steering Rate
Adjusts the steering end points
8. Steering Trim
Adjusts the steering center point
SLT2 TRANSMITTER
1
2
3
4
5
6
7
8
INSTALLING THE TRANSMITTER BATTERIES
CAUTION:
If using rechargeable batteries, charge only rechargeable batteries.
Charging non-rechargeable batteries may cause the batteries to burst, resulting in
injury to persons and/or damage to property.
This transmitter requires 4 AA batteries.
1.
Remove the battery cover from the transmitter.
2.
Install the batteries as shown.
3.
Install the battery cover.
CAUTION:
Risk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to national regulations.
CAUTION:
Never remove the transmitter batteries while the model is powered
ON. Loss of model control, damage, or injury may occur.
