EN
5
Model Assembly
A
B
Horizontal Stabilizer Installation
1. Slide the horizontal tail tube (
A
) into the hole in the rear of the fuselage.
2. Install the 2 piece (left and right) horizontal tail as shown. Ensure the
control horn faces down.
3. Secure the 2 piece horizontal tail in place with 2 screws (M3 x 10mm) (
B
)
included.
4. Press the control linkage ball link on the ball attached to the control horn.
5. Ensure the elevator and rudder servo arms are in the correct position, then
adjust the linkage to center them.
Disassemble in reverse order.
M3 x 10mm
Countersunk Machine Screw
B
Screw Chart
Location
Size
Screw Quantity
Elevator ball link screw
M2 x 8mm
1
Wing screw
M3 x 32mm
4
Horizontal stabilizer screws
M3 x 10mm
2
Spinner screw
M3 x 32mm
1
Propeller screws
M3 x 16mm
6
Tail wheel mount screws
2.0 x 8
4
Hands free servo plugs screws
2.0 x 8
8
Servo cover screws
2.0 x 8
8
Landing gear door cover screws
(inside)
2.0 x 12
16
Landing gear door cover screws
(outside)
2.0 x 6
2
Retract cover mount screws
2.0 x 8
4
Wheel axle hub screws
4.0 x 25
2
Retract motor mount screws
3.0 x 16
8
Wing plug screws
2.0 x 8
16
X Mount screws
3..0 x 16
4
Motor mount screws
4.0 x 10
4
Ball link screws
2.0 x 8
6
