EN
6
AT-6
Battery Installation and ESC Arming
Battery Selection
The E-fl ite
®
2200mAh 11.1V 3S 30C Li-Po battery (EFLB22003S30) is
recommended. Refer to the Optional Parts List for other recommended
batteries. If using a battery other than those listed, the battery should be within the
range of capacity, dimensions and weight of the E-fl ite Li-Po battery packs to fi t in
the fuselage. Be sure the model balances at the recommended CG before fl ying.
1. Lower the throttle and throttle trim to the lowest settings. Power on the
Transmitter, then wait 5 seconds.
2. Lift the hatch from the back to remove.
3. For added security, apply the loop side (soft side) of the optional hook and
loop tape
(B)
to the bottom of your battery and the hook side to the
battery tray.
4. Install the fully charged battery
(C)
in the middle of the battery
compartment, as shown. Secure using the hook and loop strap
(D)
.
5. Connect the battery to the ESC (the ESC is now armed).
6. Keep the aircraft immobile and away from wind upright and on fl at surface
or the system will not initialize.
• The ESC will produce a series of sounds. 3 fl at tones followed
immediately by 2 ascending tones if you are switching ON SAFE Select.
• An LED will light on the receiver.
7. Reinstall the battery hatch.
B
Optional
C
C
C
D
CAUTION:
Always keep hands away from the propeller. When
armed, the motor will turn the propeller in response to any
throttle movement.
