Horizon Hobby Blade Glimpse, Руководство пользователя

Страница: 9 / 24

9
EN
Transmitter and Receiver Binding
The Glimpse quadcopter requires no radio-specifi c setup for basic fl ight. If you are using a computer transmitter,
simply bind the quadcopter to your transmitter with the model type set to "Acro" or "Airplane" mode.
Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifi er) code of a
specifi c transmitter. You need to ‘bind’ your chosen
Spektrum ™ or DSM2 ® /DSMX ® technology equipped aircraft
transmitter to the receiver for proper operation. If you purchased an RTF model, the transmitter is bound to the
model at the factory.
To bind or re-bind your aircraft to your chosen transmitter, please follow the directions below.
General Binding Procedure
1. Disconnect the fl ight battery from the quadcopter.
2. Set the model type in your transmitter settings to "Acro" mode.
3. Center all trims on your transmitter.
4. Power off the transmitter and fully lower the throttle.
5. Connect the fl ight battery in the quadcopter. The blue LED on the 4-in-1 control unit fl ashes rapidly, indicating it
is in bind mode.
6. Put the transmitter into bind mode while powering on the transmitter.
7. Release the bind button/switch after 2–3 seconds. The quadcopter is bound when the blue LED on the
4-in-1 control unit turns solid.
8. Disconnect the fl ight battery and power the transmitter off.
CAUTION: When using a Futaba ® transmitter with a Spektrum module, you must reverse the throttle channel
and rebind. Refer to your Spektrum module manual for binding and failsafe instructions. Refer to your Futaba
transmitter manual for instructions on reversing the throttle channel.