14
Do not connect the RJ45 port to the phone line
2.2 SFP Port connection
PS3016GS SFP port only support Gigabit fiber module.
Recommended use of standard SFP module products
The process of installing a fiber module on a switch is as follows:
1、 grasp the optic fiber module from the side, insert it
smoothly along the SFP port slot until the optic fiber module and
switch are in close contact;
2、 confirm the Rx and Tx ports of the fiber module when
connecting, insert one end of the fiber into the Rx and Tx ports
correspondingly, ensure that the Tx and Rx ends of the interface
are connected correctly and the other end of the fiber is
connected to another device;
3、 please check the corresponding indicator light status
after power on. If the light blinking that the link is properly
connected, if the light is off , the link is failure, please check the
line to confirm that the corresponding equipment is enabled.
Note：
DO NOT excessive bending fiber, the radius of curvature should
not be lessthan 10cm;
Ensure the cleanliness of the fiber surface;
Please DO NOT look directly into the optical fiber connector with
your eyes as this may cause eye injury