HORA MC250/230, Руководство по эксплуатации

Страница: 16 / 32

4 Assembly
Linear actuators MC250 • MC253 • MC500 • MC503
16 Version 2.1 - March 2011 Operating Manual
4 Check the power supply voltage.
If the required tolerance of the power supply voltage cannot be maintained with a
mains transformer, an AC voltage regulator must be used.
 2.5 Technical data on page 10.
 Proceed as follows to switch the electrics on:
1 Remove the (201) cover.
 Proceed as follows to remove the cover: on page 14.
2 Feed the cable through the screw connector in the cover to the terminal strip.
3 Connect the electrics in accordance with the circuit diagram.

Diagram 8
on page 16
Hint: The circuit diagram (481) is located on the printed circuit board cover (33) .
ATTENTION
Malfunction due to incorrect zero potential!
If the linear actuator is electrically supplied by signal generators with different zero
potentials, this may cause incorrect dynamic performance.
• Ensure that the zero potentials are correctly used.

Table 3
on page 17
4 Tighten the screw connections.
Diagram 8 Wiring diagram