Page 2
Swing Door Handle Set
Installation Instructions
1. Apply the backplate gasket to the inside of the
exterior and interior backplates. Push gaskets firmly
into place to ensure a tight seal. Attach interior and
exterior backplates to the door and fasten loosely
with the screws provided. Note: The screw heads
must be on the interior side of the door.
2. Insert the two-piece handle shaft into one handle. Be
sure to orient the shaft as shown below. Screw the
set screw until flush with handle using the hex wrench
provided. Insert the handle with shaft attached
through the escutcheon plate and door gear handle
hole until extending out opposite side of door.
3. Install remaining handle onto shaft, pressing tightly
to the backplates. Tighten the handle set screw with
hex wrench. Screw until flush with handle.
4. Insert the keyed cylinder from the interior side of
the door until it is flush with the exterior backplate.
Install the cylinder screw in the screw hole below the
deadbolt in the edge of the door to secure in place.
5. Hand tighten the backplate screws to complete
assembly.
A Phillips screwdriver is required.
A 3mm hex wrench for set screws is
provided in the hardware package.
To prevent damage to the handle set
during the construction phase, use
the enclosed construction handle to
operate the door. Lift the handle to
engage the multipoints. Push down to
disengage.
Use water and a soft cloth to clean.
Do not use brass cleaner or solvent
based cleaning agents as they will
remove the protective coating on the
hardware.
Note: Handles and backplates vary by
style but application is the same.
See Cylinder Installation
Instructions for installing
cylinder
Exterior
Lever Handle
Exterior
Backplate
Gasket
Gasket
Interior of
Door Stile
Construction
Handle
Interior
Backplate
Required Shaft
Position for Set
Screw
Cylinder Screw
(One Provided)
Backplate Screws
(Two ro Three Provided
Depending on the Backpaltes)
Interior Lever
Handle
Lock
Cylinder
Set Screw
(Two Provided)
Nylon
Bushing
