Safety Precautions (continued)
Do not forcibly fit an abrasive wheel as this will pre-stress the wheel and may lead to
premature failure.
Disconnect from the power source when changing the wheel or working on the
grinder. When a new wheel has been fitted run the Grinder for about 15 seconds to
ensure the wheel runs true and there is no abnormal vibration.
Never operate the tool without the wheel guard.
Before commencing grinding carry out a risk assessment and any procedures put in
place are followed.
Ensure any persons cannot wander in front or to the sides of the operator whilst
grinding. To avoid the risk of injury to others cordon off the area.
Make sure the working floor area is clean so as to avoid any slipping or tripping
hazards.
This Grinder will produce sparks. Remove all flammable liquids and combustible
materials from the vicinity.
Do not use in an explosive environment.
Hold the Angle Grinder firmly with both hands at all times whilst operating.
Do not overreach, ensure you keep your balance and sure footing at all times.
Make sure that the work piece is secured and cannot move whilst grinding or cutting.
Ensure the wheel guard is positioned correctly (with the closed side towards the
operator) and keep all parts of the body away from the rotating wheel.
Do not start the grinder with the wheel in contact with a surface. Always introduce the
free spinning wheel to the work piece to be ground or cut.
Do not use a cutting wheel to grind with. Side loading the thin wheel will cause the
wheel to shatter which may result in injury or death.
When cutting do not twist or force the wheel to cut, this will cause the wheel to
shatter. Guide the wheel in a straight line applying gentle pressure and let the cutting
wheel do the work.
Never walk around with the Grinder running.
Be sure to check the area for buried utility cables or pipes. Do not operate where you
cannot be sure of their presence. It could result in serious injury or death.
5