CWL622
•
WMS & FLOOD LIGHT KIT
•
OWNER
’
S MANUAL
BLAZER-INTERNATIONAL.COM
1-800-835-0129
Page 3 of 12
Patent Pending
© Copyright 2019
HOPKINS MANUFACTURING CORPORATION
428 PEYTON ST., EMPORIA, KS 66801
www.HopkinsMfg.com | 1-620-342-7320
Troubleshooting
Symptom
Possible Cause and Solution
Battery LED light does not illuminate on the
remote control unit when buttons are pressed.
Remote control battery is dead.
Replace battery (12V A23 alkaline)
Auxiliary lights/equipment not operational when
the remote control button is pressed and the red
LED illuminates on the WMS box under the fuse.
1. Vehicle battery voltage below 9.8V +/- 0.3V
DC. Charge battery.
2. Main unit not connected/incorrectly
connected to the battery source. Check
connection and polarity of WMS.
3. Blown fuse/replace fuse.
4. Pairing between the remote and main unit
disrupted. Pair the system (see below).
Some accessories/lights will not come on.
Check wire polarity for those items.
Light/accessory comes on momentarily.
That channel is being overloaded. Make sure the
amperage of the light is less than that stated at
the terminal (check fuse).
In case the remote is lost, a replacement remote can be paired with the existing module, rather than
purchasing a new system (call customer service at 800-241-3808 for assistance). Pair the new remote
to the main unit before use.
Pairing procedure (See
FIG 3
): (Caution: Main unit and remote control are already paired when shipped
– call 800-835-0129 before trying to pair a newly purchased CWL622 kit).
• Point the remote control towards the main unit and using a small screwdriver press the black
switch. The green light will light up on the powered WMS unit.
• Now press any one of the four buttons on the remote control to pair the remote with the WMS.
The green light should turn off indicating successful pairing.
Call technical service at 800-235-0129 for any issues related to your WMS.
FIG 3
1
Indicator Light
2
Pairing Switch (Black)
FIG 3
2 1
