5
4
Replace the batteries when any of the following happens
• The
+Lo
shows
• The display dims
• The display does not light up
BEFORE YOU START
BEFORE YOU START
♥
Installing and Replacing the Batteries
1.
Slide off the battery cover on the back of the unit.
2.
Install the batteries by matching the correct polarity, as shown below.
Always use the correct battery type (2 alkaline AAA size)
3.
Replace the battery cover.
It is important to set the clock before using your blood pressure monitor
so that a time stamp can be assigned to each record stored in the memory.
(The year can be set to anywhere between 2000 and 2050.)
♥
Setting the Year, Date, Hour Format, Time,
and Measurement Units
1.
When the unit is off, press the “SET” button
once then press “SET” again and hold for 3
seconds to enter the mode settings.
2.
The [YEAR] will begin to flash. Press
“MEM” to advance to the current year.
3.
Press “SET” when you have reached
the correct year to save your choice
and advance to the next step.
4.
Repeat steps 2 and 3 to set the
[MONTH] and [DAY].
• If this device will be stored for an extended period of time, please remove the batteries
in order to avoid corrosion.
• Used batteries are harmful to the environment, so please dispose of appropriately.
Remove the old batteries from the device and follow your local recycling guidelines
• Battery corrosion is not covered under your three year limited warranty.
CAUTION
!
