S
YSTEM
P
ARAMETERIZATION AND
O
PERATION
54 / 157
System 6844(RC) - V03.00
hopf
Elektronik GmbH
Nottebohmstr. 41
• D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
5.2.8.2 Selection Frames for LAN Board 2 Parameters
Selection frame:
S E T L A N _ 2
I P - A D R .
Y / N
This display frame shows the configuration of the LAN Board coded as Board 2 (if available
in the System).
The parameters for LAN Board 2 are entered in the same way as for LAN Board 1.
5.2.8.3 Selection Frame Parameters of the LAN Management Board/Module
(System 6844RC only)
The menu is only visible on System 6844RC when the LAN Management
Board / Module is activated.
The LAN Management Board / Module is activated in the
INI Menu
.
Setting the IP address
Selection frame:
S E T L A N _ M N G
I P - A D R .
Y / N
Input frame:
L A N _ M N G
I P - A D R .
>
1 9 2 . 1 6 8
.
2 0 2 . 2 1 0
Setting the Gateway address
Selection frame:
S E T L A N _ M N G
G A T E W A Y - A D R . Y / N
Input frame:
L A N _ M N G
G W - A D R .
>
1 9 2 . 1 6 8
.
2 0 2 . 2 1 0
Setting the Network Mask
Selection frame:
S E T L A N _ M N G
N E T M A S K Y / N
Input frame:
L A N _ M N G
N E T M A S K
>
1 9 2 . 1 6 8
.
2 0 2 . 2 1 0
Setting the Control Byte
Selection frame:
S E T L A N _ M N G
C T R L . - B Y T E
Y / N
Input frame:
C T R L . - B 7 6 5 4 3 2 1 0
L A N _ M N G >
1 0 1 0 0 0 0 1
