Hoover WDYN P, Инструкция пользователя, Страница: 8 / 21

L
15
EN
The option buttons should be selected before pressing the
START button.
If an option is selected but it is not compatible with the
selected programme then the symbol first flashes and then
goes off.
NIGHT & DAY BUTTON
Press this button to reduce the intermediate spin speed to 400
rpm, where applicable; the water level is increased during
rinsing and the washing is kept immersed in water after the
final rinse in order to spread the fibres evenly.
During the phase in which the water is held in the tub, the
indicator lights to show that the machine is at a standstill.
Release the button to end the cycle with a spin dry (which
may be reduced or cancelled using the appropriate button)
and emptying phase.
Thanks to electronic control, the water in the intermediate
phases is emptied silently, making this option very useful for
washing at night.
PREWASH BUTTON
This option is particularly useful for heavily soiled loads and
can be used only on some programmes as shown in the
programmes table.
Detergent for this programme should be added to the
compartment of the soap drawer labelled
“1” (Please refer to
Detergent Drawer Section of manual). We recommend you
use only 20% of the recommended quantities shown on the
detergent pack and fabric conditioner should not be used for
this programme.
STAIN BLASTER BUTTON
By pressing this button, a sensors system come into operation.
They affect both the selected temperature, keeping it at a
constant level throughout the wash cycle, and the
mechanical function of the drum.
The drum is made to turn at two different speeds at crucial
moments. When the detergent enters the garments, the drum
rotates in such a way that the detergent is distributed in a
uniform manner; during the wash and rinse procedures,
however, the speed increases in order to maximise the
cleaning action. Thanks to this special system, the efficiency of
the wash procedure is improved WITHOUT ANY INCREASE IN
THE LENGTH OF THE PROGRAM.
H
I
14
F
EN
WASH TEMPERATURE BUTTON
When a programme is selected on the display is show the
recommended wash temperature.
The temperature button can be used to decrease or increase
the temperature of your chosen wash cycle.
Each time the button is pressed, the new temperature level is
shown on the display.
WASH TIME BUTTON
By selecting this button (active only on COTTON and MIXED
FIBRES programmes) there is a choice of 3 levels of wash
intensity, depending on how much the fabrics are soiled.
Once the programme has been selected the indicator light
will automatically show the minimum level required for that
programme. Pressing the button increases the duration of the
wash cycle, and adjusts the wash settings accordingly. For
example: Using this button on the Rapid Wash cycle will
enable you to select either a 14, 30 or 44 minute wash cycle.
DELAY START BUTTON
This button allows you to pre-programme the wash cycle to
delay the start of the cycle for up to 24 hours.
To delay the start use the following procedure:
Switch on the appliance by the ON/OFF button
Select the required programme.
Press the button once to activate it (h00 appears on the
display) and then press it again to set a 1 hour delay (h01
appears on the display); the pre-set delay increases by 1
hour each time the button is pressed, until h24 appears on
the display, at which point pressing the button again will
reset the delay start to zero.
Confirm by pressing the “ START/PAUSE ” button (the light on
the display starts to flash). The countdown will begin and
when it has finished the programme will start automatically.
It is possible to cancel the delay start by taking the following
action:
Press and hold the button for 5 seconds until the display will
show the settings for the programme selected.
At this stage it is possible to start the programme previously
selected by pressing the
START/PAUSE button or to cancel
the process by pressing the ON/OFF button.
E
G