- 8 -
User checklist
If your cleaner is not working properly run through the
following checklist.
1. Is there a working electricity supply to the cleaner?
Check with another electrical product.
2. Is the bin full or choked with fine dust?
To empty the bin, see instructions on P6.
3. Is the hose blocked?
To clear a blockage, see instructions on P7.
4. Is there a blockage in the cleaner base?
To clear a blockage, see the instruction on P7.
5. Are the filters blocked?
To clean filters, see the instruction on P6.
6. Is the nozzle height set correctly?
To set the carpet height selector, see the instruction on p4.
7. Are the brushes rotating correctly?
To check the brushes, see the instructions on p7.
8. Has the cleaner overheated?
If so, it will take about 30 minutes to reset.
If there is any doubt call the Hoover Service Office for advice. They may be able
to assist you over the telephone. A service charge will be made if the cleaner is
examined and found to be in working order, has not been assembled in accordance
with these instructions or has been used incorrectly. working order, has not been
assembled in accordance with these instructions or has been used incorrectly.
Warning!
A thermal cut out switches off the cleaner to prevent overheating if it is used when
full or there is a blockage or dirty filters. If this should happen switch off, unplug and
correct the fault.
It will take about 45 minutes for the cut out to automatically reset.
iMPOrTanT:
Do not run cleaner over the supply cord as this could damage the
supply cord insulation.
iMPOrTanT inFOrMaTiOn
Hoover Service
Should you require service at any time, please contact your local Hoover Service
Office.
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your
local Hoover dealer or direct from Hoover. When ordering parts always quote
your model number.
gUaranTEE STaTEMEnT
The guarantee conditions for this appliance are as defined by our representative in
the country in which it is sold. Details regarding these conditions can be obtained
from the dealer from whom the appliance was purchased. The bill of sale or receipt
must be produced when making any claim under the terms of this guarantee.
Subject to change without notice.
Quality
Hoover’s factories have been independently assessed for quality. Our products
are made using a quality system which meets the requirements of ISO 9001
USE OnLY HOOVEr SParES
COnSUMaBLES & SParE ParTS
CODE
PRE-MOTOR & ExHAUST FILTER KIT
U71 - 35601420
HOSE
D146 - 35601418
ExTENSION TUbE & CREVICE LONG TUbE
D145 - 35601416
FLExIbLE CREVICE TOOL
D152 - 35601659
AGITATOR
Y31 - 35601419
DUST & bRUSH FURNITURE NOZZLE
P15 - 35601415
PET HAIR REMOVER NOZZLE
J61 - 35601417
bELT
V29 - 35600744
Содержание VR81-HU01001
Страница 1: ...USER MANUAL...
