4
2. How to use
Cleaner description
The assembled cleaner will look
like the drawing.
1. Rug and floor nozzle
2. Wand storage clip:
fits into
storage slots on rear and under-
side of canister.
3. Lightweight hose
4. Spring latch
5. Telescoping extension wand:
used with rug and floor nozzle or
tools. Adjusts to desired length.
6. Hand grip
7. Suction regulator:
close for
maximum suction, open if rug &
floor nozzle is difficult to push or
lightweight rugs or draperies are
being cleaned.
8. Cord rewind pedal:
step on
pedal to rewind cord for storage.
Hold plug until cord is rewound.
9. Final filter door
10. Wand storage slot
11. ON/OFF pedal
12. Large wheels:
provide easy
towing when cleaner is pulled
over carpet, area rugs and door
sills.
13. Check bag indicator:
turns
from green to red when paper
bag should be checked for full-
ness.
14. Variable speed control
15. Tool lid:
lift lid to reveal tool
storage.
16. Bag lid
17. Bag lid latch:
lift to open bag
lid.
18. Hose connector
19. Carrying handle
20. Carpet/bare floor selector
This cleaner is intended for
household use.
Operate cleaner only at voltage
specified on data plate on bot-
tom of cleaner.
2-1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
19
20
18
Polarized plug
To reduce the risk of electric shock,
this appliance has a polarized plug
(one blade is wider than the other).
This plug will fit in a polarized outlet
only one way. If the plug does not fit
fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified
electrician to install the proper outlet.
Do not change the plug in any way.
2-2
2-3
2-4
Rug and floor nozzle
The combination rug and floor noz-
zle has been designed to do an effi-
cient cleaning job on both carpet
and hard surface floors.
The nozzle has a BARE FLOOR set-
ting and a CARPET setting. To
change from one setting to the other,
step on the pedal (C) located on top
of the nozzle.
Check bag indicator
The indicator (D) will begin to show
red as bag fills with dirt. When the
indicator is about 2/3 red, the bag
should be changed.
Listed below are three conditions that
will cause the indicator to become
completely red. Suggested solutions
are provided.
1. The bag is full; change the bag.
2. Very fine materials (such as pow-
der) have been picked up, clogging
the bag pores; change the bag, even
if it is not full.
3. There is a blockage in the nozzle,
hose, tools or at the bag opening;
remove the blockage.
A
B
C
D
ON-OFF pedal
Depress ON-OFF pedal (A) to turn
cleaner ON or OFF.
NOTE: Pedal opposite ON-OFF
pedal is the cord rewind pedal (B).
