OPERATION
6
5
Make sure water supply is
not connected. Firmly push
the water hose pipe with
suitable connector onto the
water inlet to lock
into position.
Connect water hose pipe
to a suitable water supply
and turn water on.
Before plugging the
machine in, press the
unlock safety button on
the trigger handle and
squeeze the trigger until
water starts to flow through
the nozzle.
IMPORTANT:
Always use an RCD (Residual Current Device) adaptor when using this pressure washer.
WARNING:
Don’t leave the pressure washer running when not in use, or more than 5 minutes to prevent overheating.
Before switching the machine on, the trigger handle must be squeezed to release water and to remove any airlocks
in the machine or pressure hose. Always release any build up pressure in the handle prior to disconnecting the hose.
Connect the power cord
to the mains supply via
an RCD adaptor.
Push the ‘I’ switch to turn
on. The machine will run
for a few seconds then
stop but no water will
be released.
Squeeze the trigger
on the trigger handle
to release a high
pressured water jet,
and start cleaning.
WARNING:
Don’t aim the pressure washer
directly at people, animals, plants,
electrical components, wires or the
pressure washer itself.
Push ‘O’ switch to turn off.
OPERATION
Attach both wheels
and push until they
click into place.
Attach the hose connector
to water inlet by turning
clockwise until tight.
Assembling your pressure washer
Preparing your pressure washer for use
Always make sure the pressure washer and water supply is off before connecting or disconnecting the hose and accessories.
Push the pressure hose firmly
to the water outlet and turn the
pressure hose collar clockwise
until tight.
Whilst firmly pushing the lance
into the trigger handle turn
clockwise to lock into position.
A trigger safety lock is located
underneath the handle. The safety
lock should always be in LOCKED
position before connecting/
disconnecting the pressure hose
to the trigger handle.
To remove the lance from the trigger
handle firmly push and twist the lance
anti-clockwise. When unlocked pull
to remove.
To connect pressure hose to trigger
handle, press the pressure hose
release button and push pressure
hose to lock into position.
Gently pull the pressure hose
to check the connection.
IMPORTANT:
Always make sure the trigger safety lock is in the LOCKED position when not in use or connecting
/disconnecting the pressure hose.
Always check water hose, pressure hose, lance and accessories are not damaged broken or worn before use.
After connecting pressure hose, lance and accessories check they are securely fitted and locked in place before
turning on.
Please read General Safety Information at the beginning before use.
LOCKED
UNLOCKED