Hoover HNWF 9167, Инструкция

Страница: 10 / 38

Moving the machine into
position
Your machine is heavy so care must be taken when
moving it. We recommend that two people move the
machine to avoid strain and possible injury.
● Take care not to damage flooring when moving the
machine.
●
When moving the machine to its final position take
care not to kink or damage the hose at the back of
the machine.
Adjusting the feet
Once the machine is in place the feet should be
adjusted to ensure that the machine is level. If the
machine is not level it may become noisy or move.
Adjust the feet on the front corners of the machine
until the machine is firm and level.
When the machine is firm and level, tighten the
locking nuts on the two feet.
Refer to ‘Selecting the Wash Programme’ for details of how to select programmes.
1. Turn on the water supply and check for leaks from the fill hose.
2. Switch on the electricity supply.
3. Select the spin programme and then press the Start Pause button to start the machine. Allow
the programme to continue for one minute and then cancel the programme by returning the
selector to the OFF position. This will remove any water remaining in the machine from factory
testing.
4. To check for cold water filling to the machine:
Select the rinse programme and press the Start Pause button to start the machine.
Allow the tumble action to continue until the water has pumped out. Check that the drain outlet is
not leaking or overflowing.
5. Switch off the machine at the end of the cycle by turning the programme knob to the OFF position.
6. Select the spin programme and press the Start Pause button to start the machine. If the
machine takes longer than one minute to empty check the drain hose for kinks.
Installation testing is now complete.
Now you have successfully installed the machine we advise that you run the machine to ensure the drum
is thoroughly clean after testing and storage. Select Cottons 90°C programme and run the machine for a
complete cycle using only wash detergent and water.
This programme will take approximately 2 hours to complete.
10
Testing the installation
Do not drag or lift the
machine by its door.