Refer to the ‘Selecting the programme’ for details of how to
select programmes.
1.
Turn on the water supply and check for leaks from the fill
hose.
2.
Switch on the electricity supply.
3.
Select the spin programme and then press the
START/PAUSE button to start the machine. Allow the
programme to continue for one minute and then cancel
the programme by returning the selector to the OFF
position. This will remove any water remaining in the
machine from factory testing.
4.
To check for cold water filling to the machine:
Select the rinse programme and press the
START/PAUSE button to start the machine.
Allow the tumble action to continue until the water has
pumped out. Check that the drain outlet is not leaking or
overflowing.
5.
Switch off the machine at the end of the cycle by turning
the programme knob to the OFF position.
6.
Select the spin programme and press the
START/PAUSE button to start the machine. If the machine
takes longer than one minute to empty check the drain
hose for kinks.
Installation testing is now complete.
Now you have successfully installed the machine we advise
that you run the machine to ensure the drum is thoroughly
clean after testing and storage. Select Colourfast 60°C
programme and run the machine for a complete cycle using
only wash detergent and water. Ensure that the drying timer is
in the OFF position.
This programme will take approximately
2 hours to complete.
11
Testing the installation
40003031.qxd 04/05/2005 10:16 Page 11
